Design layer types in the standards
The Layermap worksheet contains a specialized set of identifiers which control how model design layers are configured for a project file. These identifiers, which are located on the extreme right of the Layermap worksheet opposite the model layers, are used by the Setup commands to correctly configure a set of model layers for the project file.
Model layer type identifiers can take on one of the following values:
|
Identifier |
Meaning |
|
C |
Layer w/ ceiling referenced information (one per floor) |
|
F |
Foundation layer (one per project) |
|
R |
Roof layer (one per project) |
|
S |
Slab layer (one per floor) |
|
W |
Layer w/ floor referenced information (one per floor) |
|
<no value> |
Supplemental model layer |
