Adding User-defined Information to CommandsAdding User-defined Information to CommandsCertain commands permit adding to the list of available values for certain parameters (for example, the Material list for the Spring Calculator or the Units list for the Simple Beam command).
Parameters Allowing Addition of User-defined Values in the GetUserData.vss File |
|||
Group |
Plug-in Object |
Parameter |
Dialog Box |
|
1 |
Spring Calculator |
Units (inches, mm, and cm only) |
Spring Calculator |
|
|
Shaft Analysis |
Outside Diameter |
Shaft Analysis |
|
|
Simple Beam |
Beam Length |
Simple Beam: Set Beam Properties |
|
|
Simple Beam |
Deflection Units |
Simple Beam: Set Beam Properties |
|
2 |
Simple Beam |
These items are the singular form of the names in Group 1 and are used when writing the values to a worksheet and a text block on the drawing |
Not applicable |
|
3 |
Simple Beam |
Load Units |
Simple Beam: Add/Remove/Change Loads |
|
4 |
Simple Beam |
These items are the singular form of the names in Group 3 and are used when writing the values to a worksheet and a text block on the drawing |
Not applicable |
|
5 |
Simple Beam |
Section Modulus Units |
Simple Beam: Set Beam Properties |
|
6 |
Simple Beam |
Moment of Inertia Units |
Simple Beam: Set Beam Properties |
|
7 |
Shaft Analysis |
Shear Modulus Units |
Shaft Analysis |
|
|
Simple Beam |
Modulus of Elasticity Units |
Simple Beam: Set Beam Properties |
|
8 |
Spring Calculator |
Material |
Spring Calculator |
|
9 |
Shaft Analysis |
Twisting Moment Units |
Shaft Analysis |
~~~~~~~~~~~~~~~~~~~~~~~~~
