Spot00025.pngTruss Configuration Requirements

A great deal of flexibility is incorporated in the Spotlight truss object. However, in order to create a valid truss, the wide variety of configurations leads to certain restrictions in the application of truss properties.

If a truss is drawn that does not meet these requirements, an alert message is generated.

●     The width and height of the truss must be greater than three times the chord width

●     The truss hanging angle must be between -90° and +90°

●     A triangular truss must form a valid triangle

●     The chord diameter must be greater than zero

●     A pre-rigged truss cannot have lacing

●     A pre-rigged truss cannot be folding

●     Only box trusses can be pre-rigged

●     A folding truss cannot have top lacing

●     Folding is not allowed on a stacking truss

●     Top lacing is not allowed on a stacking truss

●     The top brace diameter must be less than or equal to the chord width

●     The side brace diameter must be less than or equal to the chord width

●     The connection interval must be greater than the ladder bar spacing

●     Ladder bar spacing must be greater than three times the top brace size

●     If the section is too small, lacing may not be drawn

 

~~~~~~~~~~~~~~~~~~~~~~~~~

Inserting a Straight Truss

Inserting a Curved Truss

 

www.vectorworks.net